Home Forums Air and Sea Naval How I make Ratline Shrouds

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #88283
    Avatar photoVolunteer
    Participant

    Here is the method I primarily use for making ratline shrouds for my 1/1200 ship builds. Back when I first started building Napoleonic ships I tried using common window screen material. This was much too big for the scale, so I started looking around for a replacement. I visited some local fabric shops and found a couple of possible meshes at Hancock Fabrics.

    The two examples on the right of the previous photo are my preferred meshes. The smaller one I use for the smaller ships like small unrated 2 to 10 gun boats. The other one is what I use for all the rest. Notice that the threads are thicker in one direction than the other. Our local Hancock Fabric store closed in 2016 so I bought a few yards of the mesh, enough to last forever. The description and skew number is 4″ Medium Heading 8540CL. It comes in white rolls so must be spray painted black. I also spray it both sides with a cheap fixative like hairspray to keep it from unraveling when cut into small ratlines. Even then I will paint the small cut rectangles with super glue before I cut the diagonals.

    The next step is to measure from the chains to the fighting tops and from the fighting tops to the cross tees. Now for each measurement add the width of the chains and the fighting top platforms. Now cut rectangles out matching the recorded measurements, making sure to orient the thicker threads for the long measurement and the thinner threads for the short side.

    Cut the rectangle pieces then cut diagonal across from corner to corner to make two ratlines from each rectangle. At this point I use a solder clamp set in my modeling clamp to hold the ratline.

    I cut a length of black thread, coat it with super glue and lay it across the open diagonal cut of the mesh.

    Hold the thread in place until it sets then lay it aside to dry.

    Cut the tails off and glue each ratline into place.
    That’s it. Hope this one is helpful.

     

     

    "Research is what I’m doing when I don’t know what I’m doing"
    Wernher von Braun

    #88285
    Avatar photokyoteblue
    Participant

    How cool is that!

    #88292
    Avatar photoVolunteer
    Participant

    I use fly tieing thread and am able to get tan, black, brown, etc.

    "Research is what I’m doing when I don’t know what I’m doing"
    Wernher von Braun

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.