Reply To: What’s the Japanese for ‘at last’?

[Not Connard Sage]

Guy Farrish wrote:

They (the ashigaru) look really good,. Given the nause involved in getting them right however, plus the health issues Darkest Star was outlining, I think I’ll let someone else make ’em and just buy the little beggars! I admire your perseverance and moral fortitude.

Printer resin is a different beast than casting resin. Its main hazards are contact dermatitis and chemical asthma. Well ventilated it’s not a major issue, using the cupboard under the stairs as your workspace is going to cause problems.

One day, all 3D printers will come ready set up and with built-in parameters for every sort of resin. Until then faffing about is unavoidable, although some 3D slicers have general settings for some resins that you can tweak.

 

Obvious contrarian and passive aggressive old prat, who is taken far too seriously by some and not seriously enough by others.