Home Forums Modern 15mm Modern Figures to Match With CP Models

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #70477
    Darryl Smith
    Participant

    I am looking for taller, chunkier 15mm figures that will blend well with CP Models 15mm moderns. I have Oddzial Osmy…too short and thin. Flashpoint, too short. Rebel, small and thin. Flytrap, too short. Basically CP are 17-18mm hefty figures, and seemingly many other modern ranges do not fit in well with them. Yes, I know that humans come in different sizes, but equipment would/should be the same size, and the aforementioned just do not blend. So, any other suggestions for larger, beefier 15mm moderns?

    Thanks!

    Buckeye Six Actual
    https://ambushedinthealley.blogspot.com/
    http://foragecaps.blogspot.com/
    http://germancolonialgaming.blogspot.com/

    #70490
    irishserb
    Participant

    Hey,

    I’ve been told that the early Eureka 15mm figs were a bit tall, and that Irregular’s Cold War figs are a little taller than average.  I don’t have any of either to verify that though.  You could e-mail them and ask about it.

    Is that 17-18mm dimension bottom of foot to top of helmet?

    Best of luck with your search.

    #70540
    Darryl Smith
    Participant

    Hi Brian,

    The measurement is sole of foot to eye, probably more like 16-17mm to eye then 18mm to top of head. I really like the castings, but their modern line is a tad limited.

    Thanks!

    Buckeye Six Actual
    https://ambushedinthealley.blogspot.com/
    http://foragecaps.blogspot.com/
    http://germancolonialgaming.blogspot.com/

    #70701
    Darryl Smith
    Participant

    I went ahead and ordered more CP Taliban along with some private contractors. Was going to grab some of their rear echelon Iraqis, but don’t really have a use for them yet.

    Buckeye Six Actual
    https://ambushedinthealley.blogspot.com/
    http://foragecaps.blogspot.com/
    http://germancolonialgaming.blogspot.com/

Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.