AVGP Grizzly goes to test print
This is an early version (with a wave reflector and screws), there will be another version without a shield and with boxes instead of screws. Variants of the armored personnel carrier have been made with an open and closed driver’s hatch, as well as two versions of the commander’s hatch (in the original, by the way, it should rotate) and two versions of the turret (again, an open and closed hatch). As usual, I make variants of the model where the body and wheels are both as one unit and with wheels separately.
Now the task is to check the model during 3D printing
Good looking 3d models. These would also make a good basis from anti-grav APCs.
Ha! I’ll tell you a little secret – as soon as I finish the models of armored vehicles from the Cold War, I will draw several factions with armored vehicles of the near future (about 20-40 years in the future)