Home Forums Sci Fi 6mm Sci-Fi Trying my hand at 6mm peoples

Viewing 11 posts - 1 through 11 (of 11 total)
  • Author
    Posts
  • #36515
    Avatar photoAngel Barracks
    Moderator

    I have decided to try sculpting myself and here is my first attempt, not quite finished but almost.
    Clearly with the image being bigger than the actual model, it shows up a lot of flaws but all in all not too bad so far for my first real try.

     

    #36521
    Avatar photoRules Junkie Jim
    Participant

    Hey, that’s flippin’ good! What’s he carrying, a tome of some kind? Is he a librarian?

    #36522
    Avatar photoAngel Barracks
    Moderator

    Dunno really, book, thick datapad, box, summat…

     

    🙂

    #36523
    Avatar photoLagartija Mike
    Spectator

    That’s 6mm? Pretty crisp!

    #36532
    Avatar photoEarther
    Participant

    Looks like Rick Deckard carrying a VK machine. I think he’s bloomin’ excellent for a first real go. 

    #36534
    Avatar photoMr. Average
    Participant

    Funny, I was just about to make the Deckard comparison, as well!

    Strength to strength, AB! Looking forward to seeing it in metal!

    #36537
    Avatar photoAngel Barracks
    Moderator

    Well I wasn’t going to cast it up, as I am not convinced it is good enough..?

    I will add some short hair and a broken little finger then decide (last bit was a joke…   )

    #36539
    Avatar photoMr. Average
    Participant

    “KR-16 is like any other Offworld Colony: it’s either a benefit or a hazard. If it’s a benefit, it’s not my problem.” (With apologies to Hampton Fancher)

    #36540
    Avatar photoAngel Barracks
    Moderator

    hmmm methinks a man in trenchcoat is needed.

    #36544
    Avatar photoMr. Average
    Participant

    A series of Colonial Marshals would be interesting.

    #36657
    Avatar photoAngel Barracks
    Moderator

    Now with added hair:

    And the start of some guy in shorts and sandals:

    And a scale shot with a 25mm:

Viewing 11 posts - 1 through 11 (of 11 total)
  • You must be logged in to reply to this topic.