We have a some new bits and pieces for the Joy of Six on Sunday – all 6mm scale (of course !). We have a mix of vehicles, VTOLs, starfighters and buildings to try to tempt the moths out of your wallets – none of these have been seen before in 6mm. Some of the models – especially the Squadron Commander starfighters and the Eaglewing VTOLs – will be in short supply as I don’t yet have production moulds so will only be able to bring what I can cast from the master moulds.
First up – a reminder about pre-orders. I finished stocking up for Jo6 yesterday so I will have some time tomorrow to cast up any last minute orders for collection at the show. For details about exactly what I’m bringing and how to order, click here.
So, onto the models. I was hoping to have the 6mm versions of the Flaming Sword of the Holy Brotherhood ready but we haven’t quite managed to get all of them done in time. However, I will have stocks of their largest vehicle, the M12L14 Tank Destroyer. This turretless beast is armed with a 20cm powergun and can go toe-to-toe with a Slammers M2 tank.
At Salute we released a 15mm VTOL, the Demeter. On Sunday we go one better with two new 6mm VTOLS, the Demeter (r) and its cousin, the Perseus. The former is an attack VTOL while the Perseus is a small troop carrier – the equivalent of a UH-1 Huey.
This one is brand new – it’s currently going under the codename of Rapier, although that may change 🙂 It’s a heavy tank used used by Anders Legion, who are rolling it out to replace their Cutlass tanks, and has a heavy cannon plus a missile pod. Expect to see this in 15mm very soon too.
As mentioned, we have two new starfighters in the Squadron Commander range. The first is the AmRep Raptor attack fighter. This has four X-foils with torpedo pods sandwiched between them either side and twin gatlings. The Germans get the Kondor two-seat heavy fighter, with it’s remote rear gun turret. I did make versions of both of these ages ago which never went into production, but these are brand new digital sculpts. Both will be available singly or in flights of four.
This handy little building is a radar dome – a conventional radar dish is enclosed in a protective dome to keep out the effects of weather, sandstorms, small animals etc.
Largest of all is this power station cooling tower. We’ve had a hollow 3D-printed item in our Shapeways shop and we’ve sold a few of these at shows, but this is a much larger resin version – at over 4″ tall, it’s almost twice as large as the 3D printed model.
But, much to my annoyance, I forgot to bring one home from the workshop to photograph, so for now you’re left with this enigmatic silhouette… (I’ll try to remember one tomorrow !).
HS6-2011 – M12L14 Tank Destroyer – £1.50
HS6-2601 – Perseus Utility VTOL – £2.00
HS6-2602 – Demeter Attack VTOL – £2.00
HS6-3601 – Rapier Tank – £1.25
SCR-203 – Raptor Assault Fighter – £3.00
SCP-203 – Raptor Flight – £11.00
SCR-303 – Kondor Heavy Fighter – £3.50
SCP-303 – Kondor Flight – £13.00
B300-144 – Radome – £2.00
B300-145 – Power Station Cooling Tower – £10.00
For those who can’t make the show, most of these models will be trickling onto the website in the near future. For those who can, please come and say hello on Sunday, but be gentle with me – I’ll be at a wedding the day before and although I won’t be hungover (I have to drive to Sheffield from Kent on Saturday evening) I may not have had much sleep…